Clik here to view.
General discussion • "Active Cooler" thermal pad size
Hello,I have the old "Active Cooler" (no thermal pad for the RP1 and small changes like the spring) on my older PI5 and the new "Active Cooler" since yesterday on the new PI5.As you can see in the...
View ArticleAdvanced users • HTTPS for Network Install
Please consider updating the network installer image to use HTTPS. The network installer does not work on networks where the firewall blocks port 80.The network installer image itself is fetched over...
View ArticleCamera board • Re: raspi-Camera for ClimateChamber
The operational temperature range of image sensors is generally -20~ 60 degree (C), And the plastic lens cannot guarantee the images in higher temperature (defocus/distortion), you should use...
View ArticleClik here to view.
Bare metal, Assembly language • Re: MMU Intermediate Physical Address size
Mystery solved... From section "D5.1.3 VMSA address types and address spaces" of "ARM Architecture Reference Manual ARMv8, for ARMv8-A architecture profile" I read...• The top VA subrange runs up to...
View ArticleSDK • Re: PIO register value at init and at enable
They keep the values they had before (i.e. unchanged).Statistics: Posted by PicoTinker — Sat Jan 18, 2025 1:37 am
View ArticleNetworking and servers • PI5 WiFi6 rtl8552au or Intel ax200?
I need to get wifi6 working on my PI5, after some research it seems like the rtl8552au and Intel ax200 chipsets seem to work, can anyone tell me which of these work either out of the box or at least...
View ArticleCompute Module • Re: CM5 pwr & act LED behavior different than CM4
Reverse the logic of the two LEDs in hardwareStatistics: Posted by qiangyou_peng — Sat Jan 18, 2025 2:29 am
View ArticleGeneral discussion • Whether ID EEPROM count as programmable GPIO pins
I am a university student. And this problem came up in my homework. My question is do ID EEPROM, namely physical pin 27 and 28, count as programmable GPIO pins? For a Pi 4 Model B, answer the...
View ArticleAutomation, sensing and robotics • Re: Sine Wave R/W - Frequency Identification
It's going to be really hard for you to do since you don't actually seem to know anything.Here's a patent document describing something that appears to match what you are looking...
View ArticleBeginners • Re: Raspberry Pi 5 came with no SD card
Alas, two new issues have arisen:1.) I purchased a SmartQ card reader from Amazon, as well as a SSD 256GB NVMe card from Pi Shop. However, when I inserted the card into the reader and the reader into...
View ArticleHATs and other add-ons • Re: Raspberry Pi 5 with Flirc - Idle Temperature?
You got some results meanwhile? What was your decision?Statistics: Posted by e-raser — Sun Jan 19, 2025 12:18 am
View ArticleTroubleshooting • Pi5 not booting
I have read the sticky. The status led blinks 4 long - 5 short (Fatal firmware error).I do not get any output when plugging an hdmi in, with or without an sd card.I tried wiring the uart in the gpio...
View ArticleHATs and other add-ons • Re: Pi 5 Fan socket
Raspberry pi 5 fan connector? - Page 2 - Raspberry Pi Forums https://search.app/4kU9NXqBSt7WTTmt7Thankyou, I managed to find that post after maybe an hours search (I did try and not just let someone...
View ArticlePython • remove jitter from servo?
I have some python code that works but the servo is way to jittery for my usecase, I have no idea what I'm doing wrong tho. can anywone helpCode: from gpiozero import AngularServofrom time import...
View ArticleClik here to view.
MicroPython • Re: Pico and OLED Screen (OSError: [Errno 5] EIO)
The other possibility is that the interface mode need to be set. The boards have one of the two enabled. In the following link, a similar board need changes to jumpers:Thank you so much @katak255....
View ArticleAdvanced users • SSH fails on Pi5-8GB with USB -SSD Boot
Image created with latest Pi imager and SSH is enabled - Pi Connect works finebut SSH always says bad password regardless of what I reset it to manually.Am using a 47W power charger from Canakit with...
View ArticleAdvanced users • Re: SSH fails on Pi5-8GB with USB -SSD Boot
Image created with latest Pi imager and SSH is enabled - Pi Connect works finebut SSH always says bad password regardless of what I reset it to manually.What other computer are you using to SSH into...
View ArticleClik here to view.
HATs and other add-ons • Re: "Active Cooler" thermal pad size
I tried again and got it!I have now cut the pads to the exact size and stacked them. The side with the PMIC is slightly higher but everything is in place! The temperatures are better now too!I hope...
View ArticleClik here to view.
General • Re: Pico Cannot Handle Multiple Servos ?
Very interesting, here is another case. I'm guessing the DC-DC section gave up the magic smoke... See this thread from a few months ago:Pico W overheating/fried using servo driver...
View ArticleCamera board • shortest quality lens for use with GS camera?
Hi, the lens I have for my global shutter camera is this one. I'm attempting to stuff this camera into the body of a dead game camera, but it isn't short enough to close the front and back of the game...
View Article